Setting Up The System; Precautions; System Connection - Sony SX-M700A Operating Instructions Manual

Setting Up the System

Precautions

Safety precautions
Power supply
• Operate the unit only with a power source as
specified in "Specifications" section.
• Do not drop or place heavy objects on the power
cord. If the power cord is damaged, turn off the
power immediately. It is dangerous to use the unit
with a damaged power cord.
• Disconnect the power cord from the AC outlet by
grasping the plug, not by pulling the cord.
Keep foreign objects out of the cabinet
Dropping flammable or metal objects into the cabinet,
or spilling liquids onto the cabinet can lead to
accidents.
In case of malfunctions
If you notice any unusual sound, smell or smoke, turn
off the power immediately, disconnect the power
supply and contact your Sony dealer.
Cleaning
Clean the cabinet and panels by wiping with a soft,
dry cloth. For severe stains, moisten the cloth with a
small amount of neutral solvent, and finish by wiping
with a dry cloth. Do not use alcohol, benzine, thinner
or volatile liquids, as these may discolor or damage
the cabinet surface.
16

System Connection

This section explains how to connect the system.
Chairman's unit/delegate's unit and
interpreter's unit
The SX-M700A Control Unit is provided with four
DELEGATE'S/CHAIRMAN'S UNIT connectors and
two INTERPRETER'S UNIT connectors. Up to 15
chairman's/delegate's units can be connected to each
of the DELEGATE'S/CHAIRMAN'S UNIT
connectors in serial connection. The distance between
the control unit and the last chairman's/delegate's unit
should not exceed 60 meters (196.8 feet).
A total of seven interpreter's units can be connected
to the two INTERPRETER'S UNIT connectors. For
example, three units can be connected to one
connector and four units to the other. The distance
between the control unit and the last interpreter's unit
should not exceed 60 meters (196.8 feet).
Notes
• Be sure to turn off the power of any units before
attempting connection or disconnection.
• If you turn on the system power before connecting
the chairman's unit/delegate's unit, the microphone
indicators and MIC ON/OFF buttons continue to
blink and these units cannot be controlled by the
control unit. In such a case, turn the power off, then
back on again.
• When using the INTERPRETER'S UNIT
connectors (20-pin multi-connector) and
DELEGATE'S/CHAIRMAN'S UNIT connectors
(20-pin multi-connector) of the control unit, attach
the dust caps removed from the 20-pin multi-
connectors on the control unit to the 20-pin multi-
connectors on the last unit connected.
If the 20-pin multi-connector has no dust cap, keep it
away from metal tools, such as screwdrivers to
prevent the connectors being inadvertently shorted.