Table of Contents
Advertisement
S
R
ETTING THE
EMOTE
Your NSP uses the following table when programming your remote control ID to work with each TV in your household. You
may use it, too.
Remote Control ID
0
Local TV1--TV in same room as RG. Remote is set to operate in IR mode.
1
Remote TV1--TV in a different room than the RG.
2
TV2 (remote TV).
3
TV3 (3-stream models only).
To program the remote control ID:
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press the A key. The remote is now in programming
mode.
4. Enter the single-digit remote control ID from the table
on page 39.
C
ID
ONTROL
SRC-300
Operates TV
1. Press and continue to hold the A button until the LED at
the top of the remote flashes rapidly.
2. Enter the following three-digit sequence: 7-8-9. The
remote is now in programming mode.
3. Enter the single-digit remote control ID from the table
on page 39.
Mode
IR
UHF
UHF
UHF
SRC-200
39
Advertisement
Table of Contents
