Air Cleaner Set-Up; Operating The Remote Control; Using The Remote Control; Power - Kenmore ENVIROSENSE 85500 Operator's Manual

Using the Remote Control
Improper use:
, Any location where there is inverter
lightingequipment or electronic
spontaneous lighting equipment,
• When cleaning unil Is located in direct
sLmiight, as sunlightmay interfere with
the infrared sensor.
• In areas where fluorescent lighting is
flickering due to worn out bulbs.
Proper use"
• Operate with tile remote control facing
the air cleaner.
, Operate within 23 feet of the _{r cteaner.
• Make sure there are no objects between
the remote control and the unit.
OPERATING THE REMOTE CONTROL
• POWER
Use the POWER button to turn the power
on and off. A short beep will sound when
you turn the unit on or off, Once the unit
is on, it will automatically switch into
Automatic operation,Turn the unit to
manual contmt by pressing one of Ihe
FAN CONTROL buttons.
• OFF TIMER
This button is used to set the timer.
Press the button repeatedly to set the
unit to run for 1, 4, or 8 hoursor to
cancel. Each time you press the button,
it will advance to the next pro-set amount
of time, The indicator light on the unit
will show the remaining amount oftime.
The unit will stop operating when the set
amount of time runs out,
• FAN CONTROL
• UP
Use this button to switch from
Automatic operation and increase the
fan speed level.
• DOWN
Use this button to decrease the fan
speed level.
• TURBO
Use this button to switch from
Automatic operation and begin the
maximum amount of room cleaning
end air movement.
• AUTO/SLEEP
Use this button to switch between
Sleep_operatiOn and Automatic
ope;_ion.
• PLASMA CONTROL
Use this buttonto turn the
PlasmaDoctor on or off.
i POWER button !=......
AUTOISLEEP bu_on _ ......
[ OFF TIMER button 1 - .....
_m
I
....
---tTo.BObot, I
--t FAN CONT.OL o.oo t
Note: Follow these instructions for best
results.
• Place unit at least 7 feet from equipment
that emits electric waves such as
televisionsor radios.
• Place unit at least 2 feet from the wall.
• Keep sensors away from drafty areas.
• Keep curtains away from sensors, as
they may interfere with air intake;outlet.
° Place unit on a stable surface with plenty
of air circulation.
1. Remove protective film from the control
panel.
2. Remove the front panel by pullinggently
on the silver labs
located on each side
of the unit,
3.Pull out the lilte_cassette by grasping the
black tabs located
on each side,
4. Remove the plastic wrap from the
filter cassette,
5. Place the filter cassette back _,,,3m
main unit.
6, Replace the front panel by hooking the
panel on the top pf the
unit. Swing pane] in
by pushing gently on
the silver tabs located
on each side of the unit
and then lock it into
place.
7. Plug in the power cord to a wall outlet.
8. Press POWER button until a short =beep"
|s heard.
POWER
For the first 4 minutes after Ihe unit is
turned on, the unit wiltcheck the air
quality, and the dust and odor pollution
level indicatorswill gash,
?2 "°
::: EZ
L_