INSTALLATION OF TRANSDUCER (THRU-HULL)
●Work on the board is too unstable and risky.
Installation and maintenance of transducer should be done after you land and
fix the boat.
Unless you keep it, human damage resulting in death or serious wound will
occur.
●Installation of the transducer inside the hull with adhesive should be done
while you ventilate well inside the boat.
Volatile gas from solvent or etc. causes to toxic symptoms.
●Perfect waterproof treatment should be done when you install the transducer
through the hull.
If waterproof is not sufficient, it causes to marine disaster because water comes
in.
●When you work using electric tools, please keep your hands dry.
If you hands are wet, it causes to electric shock.
※Do not install on the aluminum boat. (It may cause to corrosion.)
Installation of transducer (Thru-hull)
(1) Make an approx. φ25 hole on the bottom. (Do not install on the aluminum
boat. It may cause to corrosion.)
(2) Insert screw of transducer into hole and fix with one cork packing, one
washer and one nut. (Another one cork packing is reserve.)
※ Put the seal at joint point for waterproof.
When bottom of boat is tilted, install the transducer after putting block
on below figure so that transducer points just under the boat.
※ Size and figure of transducer differs depending on output power.
36