Setting Up The Printer - Fujitsu PRIMERGY BX620 S4 User Manual

Chapter 2 Checking before OS Installation
Configuration file (SerStartBatch.ini)
A configuration file stores the server setup and client information configured in ServerStart. To create a
configuration file, use the ServerStart floppy disk. Store only one file on each floppy disk. Do not set the
ServerStart floppy disk to the write-protected state. You can use any name for the configuration file.
However, the file must be installed in the server as "SerStartBatch.ini". When installing the
configuration file, make sure to save it as "SerStartBatch.ini" on the ServerStart floppy disk. Start up
ServerStart, insert the ServerStart floppy disk containing "SerStartBatch.ini", and click [Start] to install
the server
Ejecting PRIMERGY Startup Disc
Do not eject PRIMERGY Startup Disc while ServerStart is running. If the PRIMERGY Startup Disc is
ejected and inserted again, ServerStart starts up in multiple windows, and settings you have made may
be lost.
Exiting ServerStart
After operation in the expert mode, exiting ServerStart restarts the system. Remove discs from the
floppy disk and CD/DVD drives and click [OK]. When the display on the screen disappears, turn off the
system.
License for use of system for ServerStart
"License for Use of System for ServerStart" linked from the ServerStart startup window is a license for
use of Windows PE contained in ServerStart of the PRIMERGY Startup Disc. Windows PE for starting
up ServerStart can be only used for installing Windows Server 2008, Windows Server 2003 R2, and
Windows Server 2003, provided under a separate legal license.
Display of onboard LAN
Display of an onboard LAN on your OS is as below when OS installation performs with ServerStart.
LAN Port
Onboard LAN
Adapter numbers
For ServerStart, onboard multiple LAN adapters (network adapter) may be configured on OS
installation wizard.
To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and
enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the
order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always
applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are
configured as intended.

Setting up the printer

ServerStart does not support setup of printers. Perform installation after setup is completed.
44
table: Display of Onboard LAN
Property on My Network
Local Area Connection
LAN Device Name
BroadcomNetXtreme Gigabit Ethernet