Connecting Other Equipment; Adjusting The Voltage Selector; Cancelling The Display Demonstration - JVC MX-K5 Instructions Manual

Connecting Other Equipment

You can connect an audio equipment.
• DO NOT connect any equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
To audio output
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
VOLTAGE
SETTING
Using a screw driver, set the voltage selector so that the arrow
on printed on the rear points the correct voltage where you
use this unit. (See the back cover page.)
AUX IN
Audio equipment
220
220
VOLTAGE
SETTING
NOW, you can plug in the unit and other
connected equipment FINALLY!

Cancelling the Display Demonstration

When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press
DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing DEMO.
To start the display demonstration manually
Press and hold DEMO again for more than
2 seconds.
– 8 –
CANCEL
/DEMO
CANCEL
/DEMO