Common Operations; Turning On Or Off The Power; Setting The Clock; Selecting The Sources - JVC HX-Z30 Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
STANDBY/ON on the remote
control) so that the STANDBY lamp
goes off.
To turn off the unit (standby), press
(or STANDBY/ON on the
remote control) again so that the
STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "AM 12:00" immediately, while the tuner
preset stations (see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. "AM 12:00" will flash on the display until you set
the clock.
• You can set the clock whether the unit is on or off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn ¢ / 4 to
adjust the hour,
then press
SET/DISPLAY.
The minute digits start
flashing on the
display.
To correct the hour after pressing
SET/DISPLAY, press CANCEL/DEMO.
The hour digits start flashing again.
9
(or
STANDBY
STANDBY
CLOCK
/TIMER
SET
/DISPLAY
CANCEL
/DEMO
3
Turn ¢ / 4 to
adjust the
minutes, then
press
SET/DISPLAY.
To check the clock time while playing a source
Press and hold SET/DISPLAY.
• Each time you press and hold the button, the source indication
and the clock time alternate on the display.
To adjust the clock again
If you have set the clock before, press
repeatedly until the clock setting mode is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY TIMER
(Daily Timer setting)
Clock
Canceled
setting
(The hour digits start flashing.)
• When you unplug the AC power cord or if a power failure
occurs
The clock loses its setting and is reset to "AM 12:00." If this
happens, set the clock again.
• The clock may gain or loss 1 to 2 minutes per month
If this happens, reset the clock.

Selecting the Sources

Press one of the source buttons—FM/AM, CD 3¥8,
TAPE 2 3, and AUX.
When you press one of the source buttons (FM/AM,
CD 3/8, TAPE 2 3, and AUX), the unit turns on and starts
playing the source if it is ready.
• To listen to the FM/AM broadcasts, press FM/AM.
(See page 12.)
• To play back discs, press CD 3¥8. (See pages 13 – 19.)
• To play back tapes, press TAPE 2 3 . (See page 20.)
• To select an external component as the source, press AUX.
AUX FM / AM
SET
/DISPLAY
CLOCK/TIMER
REC
TIMER
(Recording Timer setting)
TAPE CD