Attaching the Supplied Plate
If the unfinished surface of the front lens mount is exposed
after attaching a lens, use the supplied plate (not available
for HDLA1507) to avoid leaving this surface exposed. The
supplied plate is not technically necessary, but is suggested
for aesthetic purposes.
Unfinished surface of lens mount may be
exposed, depending on the lens attached.
Attachment procedure
1
Remove the three blind bushes from the screw holes in
the side panel.
Blind bushes
2
Attach the plate using the two supplied screws
(+B4×6).
Screws (+B4×6)
Plate
22
Installation
Note
Do not use the supplied plate if the lens and lens mount
profiles mate precisely (no unfinished surfaces exposed).
Doing so will create a space between the lens and lens
mount, resulting in inaccurate focal length adjustment.
Gap between lens
and mount