Installation And Connection (Wb-1540); Disassembling The Housing; Mounting The Camera; Tk-C625 - JVC WB-1540 Instruction Book

Installation and Connection (WB-1540)

Disassembling the Housing

Safety Wire
1.
Mounting the Camera (TK-C625)
Interior of Housing
Safety Wire
Main Board
2.
1.
AC 24 V
Output Cable
3.
To [POWER INPUT AC 24 V]
Terminal of Ceiling Mount
Camera
6
Main Housing Unit
2.
Screw A (M4 x 6) x 3
Lower Housing
Gasket
Gasket Gland
Screw B (M4) x 6
Notch
JVC Mark
Camera Mounting Bracket
Cables
Cover
FRONT
Mark
Ceiling Mount
Screws Supplied
(M4 x 20) x 4
4.
1.
Dismantle the gasket and gasket gland
Loosen the 6 Screws B (M4) using a driver, followed by
dismantling the gasket and gasket gland from the lower
housing.
T The 6 Screws B (M4) cannot be totally removed from
the gasket to prevent it from falling off.
2.
Dismantle the lower housing
Loosen the 3 Screws A (M4 x 6) using a driver, followed
by dismantling the lower housing from the main housing
unit.
T The lower housing is connected to the main housing
unit using a safety wire.
CAUTION:
Pay careful attention to store the dismantled parts and
screws until assembly is complete to prevent them from
being misplaced.

TK-C625

Before mounting.
Remove the ceiling mount cover of the camera and guide the
cables supplied with WB-1540 through the cover.
T For further details, please refer to the instruction manual of
the camera in use.
1.
Connect the AC 24 V output cable to the camera
Connect the AC 24 V output cable of the main board to
the camera's ceiling mount bracket.
2.
Connect other cables
Connect the necessary cables supplied with the housing
(coaxial video cable, communication cable, etc.) to the
ceiling mount.
CAUTION:
● Connect the communication cable to the [ALARM IN/OUT]
and [CONTROL] terminals if necessary. For safety
reasons, ensure to cut off any excess cable and bind using
an insulating tape before use.
● For further details on connection, please refer to the
instruction manual of the camera in use.
● Ensure to bind connectors of LAN cables and DC 12 V
Power Cable that are not in use with an insulating tape
before use.
3.
Mount the camera's ceiling mount to the main
housing unit.
Use the 4 screws supplied (M4 x 20) to mount the ceiling
mount to the main housing unit.
NOTE:
During mounting, align the [D FRONT] Mark of the ceiling
mount with the notch on the camera mount bracket of the
main housing unit.
4.
Mount the camera to the ceiling mount
Follow instructions in the manual of the camera in use to
mount the camera to the ceiling mount.