Table of Contents
Advertisement
Installation and Connection
Cable Connection
1.
Connecting the coaxial cable (A Pg. 17)
Lower the protection cover and connect the
connectors. Upon connecting, cover the
connectors using the protection cover.
2.
Connecting the AC 24 V/DC 12 V power
supply wires
Note:
● To mount a heater (sold separately) to this
unit, make sure to connect it to an AC 24 V
supply during use.
3.
Connect the alarm cable.
(TK-C215VP12U/E only)(A Pg. 18)
4.
Binding the AC 24 V/DC 12 V power
supply wires and alarm signal wires (TK-
C215VP12U/E only) with insulating tape
Make sure to bind the connecting portions of AC
24 V/DC 12 V power supply wires and alarm
signal wires (TK-C215VP12U/E only) with
insulating tape.
5.
Wrap insulation tape around cables.
6.
Storing cables
Upon connecting, push the connector into the
cable storage space of the camera unit.
Note:
● When mounting the camera to the electrical
box, push the connector into the electrical
box.
● While the camera unit is disconnected from
the base, be extremely careful not to drop the
camera unit.
Protection Cover
Coaxial Cable
*TK-C215VP12U/E is used in the above illustration
S
]
2
Solder or Caulk
Insulating Tape
1
Bind
insulating
3
tape
AC 24 V/DC 12 V
Power Supply
Wire
Alarm signal Wire
(TK-C215VP12 only)
4
Cable Storage
Space
Advertisement
Table of Contents
