Table of Contents
Advertisement
Control Panel
A
[Rx/Tx] Indicator
This indicator lights up during communication with the
computer using the RS-232C terminal. (A Page 15)
[Rx] : Lights up when this unit is receiving RS-232C
data.
[Tx] : Lights up when this unit is sending RS-232C
data.
B
[MENU] Button
Press this button to display the menu. Pressing this
button when the menu is displayed clears the menu.
(A Pages 29, 30)
C
[EXIT] Button
Press this button to return to the previous hierarchical
menu (for example, to return from submenu to main
menu). Pressing this button when the main menu is
displayed clears the menu. (A Pages 29, 30)
D
[ZOOM T/W] Button
Press this button to change the size of the projected
image. (A Page 26)
E
[FOCUS +/-] Button
Press this button to adjust focus of the projected
image. (A Page 27)
A B C
RS232C
Rx
Tx
MENU
D E
F G
F
Cursor [J / K / H / I] Buttons
Use these buttons when adjusting the menu items.
(A Pages 29, 30)
G
[ENTER] Button
Press this button to show the next hierarchical menu
(for example, to enter submenu from main menu). It is
also used when ENTER is displayed against a
selection item on the menu screen. (A Pages 29, 30)
H
[OPERATE ON] Button
When this unit is in the standby mode, pressing this
button for more than 1 second will turn the unit on and
cause the [OPERATE] indicator to light up.
(A Page 26)
I
[OPERATE OFF] Button
When this unit is operating (projecting), pressing this
button for more than 1 second switches the unit to the
cool down mode, which will automatically switch to the
standby mode after about 60 seconds. (A Page 27)
● The [OPERATE OFF] button will not work within
approximately 1 minute after the light source has been
turned on. Start operation only after 1 minute's time.
J
[HIDE] Button
Use this button to temporarily clear the video image.
Press again to resume. (A Page 27)
OPERATE
EXIT
ON
H
OPERATE
OFF
I
HIDE
J
13
Advertisement
Table of Contents
