Honeywell T7200D Product Data page 11

T7200D,E, T7300D,E,F AND Q7300 SERIES 2000 PROGRAMMABLE COMMERCIAL THERMOSTATS AND SUBBASES
— To advance to the next Installer Setup number, press the
Unoccupied Temp key.
— To return to an Installer Setup number, press the Heat/
Cool Settings key.
— To change a setting, use the increase
key.
— To exit the Installer Setup, press the Run Program key.
The Installer Setup is automatically exited if no key
presses are made for four minutes.
NOTE: Be sure to set the thermostat time after exiting the
Installer Setup.
Installer Setup numbers are listed in Table 8.
Installer Setup
Number
(Press
Unoccupied
Temp key
to change)
Select
Not used 1
a
Fan operation 2
Output stages of 3
heating
Heating cycle 4
rate
5
6
7
Output stages 8
of cooling
9
Cooling cycle
rate
10
11
System setting 12
adjustment
(models with
System key)
Not used 13
Degree tempera- 14
ture display
Displaying 15
temperature
Clock format 16
a
Number 2 must be set to 1 to extend fan operation.
or decrease
Table 8. Thermostat Installer Setup Options.
Factory-Setting
Display Description
— —
0 Conventional
applications where
equipment controls fan
operation in heat mode
Depends Stages of heat
on
subbase
4 Stage 1—4 cph
4 Stage 2—4 cph
4 Stage 3—4 cph
4 Emergency heat relay
is on continuously.
Highest stage of heat
cycles at 4 cph
(Q7300C or D only).
Depends Stages of cooling
on
subbase
4 Stage 1—4 cph
4 Stage 2—4 cph
4 Stage 3—4 cph
Depends System selection
on model
— —
0 Temperature is
displayed in °F
0 Temperature is
displayed
0 12-hour clock format
11
CAUTION
Heat pump and electric heat systems must be
configured correctly in Installer Setup 2 to prevent
equipment damage caused by the system running
without the fan.
IMPORTANT
Only configurable numbers are shown on the device.
Example: If the thermostat does not have a system
key, Installer Setup number 12 will not be displayed.
Review Table 8 factory-settings and mark any
desired changes in the Actual Setting column. When
the Installer Setup is complete, review the settings to
confirm that they match the system.
Other Choices
(Press or
Display
—
1 Electric heat applications where
thermostat controls fan operation in
heat mode
0, 1, 2, 0—No heating
or 3 1—One stage of heat
2—Two stages of heat
3—Three stages of heat
3, 6, 8 3—3 cph used for hot water systems
or 9 or high efficiency furnaces
6—6 cph used for conventional
systems
8—8 cph used for conventional
systems
9—9 cph used for electric heat
systems
0, 1, 2 0—No cooling
or 3 1—One stage of cool
2—Two stages of cool
3—Three stages of cool
3 3—3 cph
0, 1 or 2 0—System setting key is operational
1—Auto setting is disabled
2—Auto only setting
—
Temperature is displayed in °C
1
1 Temperature is not displayed
1 24-hour clock format
key to change)
Actual
Setting
Description
—
—
(Continued)
63-4355—1
—
—