Kenwood DNN991HD Quick Start Manual page 20

• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
• Connect the speaker wires correctly to the terminals
to which they correspond. The unit may be
damaged or fail to work if you share the ¤ wires or
ground them to any metal part in the car.
• When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear output
terminals (do not mix front and rear). For example,
if you connect the ¢ connector of the left speaker
to a front output terminal, do not connect the ¤
connector to a rear output terminal.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Mount the unit so that the mounting angle is 30°
or less.
• This unit has the cooling fan (P.24) to decrease
the internal temperature. Do not mount the unit in a
place where the cooling fan of the unit are blocked.
Blocking these openings will inhibit the cooling of
the internal temperature and result in malfunction.
• Do not press hard on the panel surface when installing
the unit to the vehicle. Otherwise scars, damage, or
failure may result.
• Reception may drop if there are metal objects near
the Bluetooth antenna and WI-FI receiver.
Bluetooth antenna area
M4 x 8mmMAX
GPS
iDalalink
iPod/
I/F
AV-IN2
PTT
POWER
EXT
I/F
L
• Install the WI-FI receiver besides the place enclosed
by the metal.
20
ñ English
WiFi
Recever
5V=500mA
WI-FI receiver
6
HOME
Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1 ...1
2 ...1
3 ...2
...1
4 *
1
...1
5 *
1
6 ...6
(M5x6mm)
7 ...6
(M5x7mm)
8 ...1
9 ...1
(3.5 m)
0...1
- ...1
(3 m)
...1
= *
1
(3 m)
~ ...1
* 1 DNN991HD only