Honeywell Satellite Receiver Installation Manual page 3

Link remote control to wireless network
WIRELESS SETUP
Press to link another
EIM or zone panel
YES
CONNECT MORE?
Link outdoor sensor to wireless network
Press and release
CONNECT
Press to save
and exit
NO
Español: vea la página 7 • Français : voir la page 13
1 Make sure the Connected light on the
EIM or wireless adapter is flashing
(see page 2).
2 Press
CONNECT
be a short delay as the remote seeks
a signal from the wireless network.
3 When the screen displays
"Connected," press
4 Press at the next screen to save and
NO
exit. (Or press
to link another EIM/zone panel.)
If E1 appears, see error codes on page 5.
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right corner of the screen
until the display changes (about 3 seconds)
1 Make sure the Connected light on the
EIM or wireless adapter is flashing
(see page 2).
2 Press the
CONNECT
of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
(If there is more than one EIM/zone
panel, repeat steps 1-3 for each.)
3
at the remote. There will
.
DONE
and repeat steps 1-4
YES
button on the back