Throttle Cable Inspection And Adjustment - Yamaha WaveRunner XLT1200 Service Manual

INSP
ADJ
CONTROL SYSTEM
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint and tighten the
locknut.
Locknut:
6 N • m (0.6 kgf • m, 4.3 ft • lb)
NOTE:
If the steering cable cannot be properly
adjusted by the cable joint at the steering
master end, adjust the cable joint at the jet
pump end so that the same clearances are
obtained. Refer to "REMOTE CONTROL
CABLES AND SPEED SENSOR LEAD" in
Chapter 8.

Throttle cable inspection and adjustment

NOTE:
Before adjusting the throttle lever free play,
adjust the trolling speed.
1. Measure:
Throttle lever free play a
Out of specification → Adjust.
Throttle lever free play:
4–7 mm (0.16–0.28 in)
2. Adjust:
Throttle lever free play
Adjustment steps:
Remove the handlebar cover.
Loosen the locknut 1.
Turn the adjuster 2 in or out until the
specified free play is obtained.
3-3
E