Table of Contents
Advertisement
13.2 REMOVING LOWER DOME MODULE, CONTINUED
13.2.2 Indoor Back Can with Digital Interface
NOTE: Handle the dome from the flange or trim ring.
1. Remove power to the unit.
2. If the lower dome module was installed for CE compliance, remove the 2-56 lock
screw on the lower dome module trim ring using a 5/64" hex key.
3. Rotate the lower dome module counterclockwise and lower the lower dome
module.
4. Slide the ball on the safety lanyard (between the top and lower dome module) up
and out of the clip on the top dome.
13.2.3 Weather Dome
1. Remove power to the unit.
2. Using a Phillips screwdriver, turn the fasteners on the lower dome module ¼-turn
counterclockwise and lower the lower dome module.
3. Loosen and remove the screw that secures the safety lanyard cable to the lower
dome module.
13.3 REMOVING THE KD6i SCAN FROM THE BACK CAN, PENDANT DOME,
OR WEATHER DOME
1. Remove power to the unit.
2. Remove the lower dome module. Refer to
for your equipment.
3. Remove the inner dome by turning the two ¼-turn fasteners counterclockwise.
Slide the liner out of the "U-bend" on the liner mounting bracket.
NOTE: It is not necessary to remove the inner dome in order to remove the scan
from the back can, etc. It may, however, make the task easier to remove the inner
dome.
4. Hold the scan with one hand and pull down on the two release latches (one at a
time) with the other hand. DO NOT LET GO OF THE SCAN AT ANY TIME.
5. Pull the scan assembly out of the back can or pendant dome.
Rev. D
Section 13.2
84
and follow the instructions
KDMU000799
02/6/04
Advertisement
Table of Contents
