Figure 5-5: Heater Element; Heater Element(S) - Replacement; Inlet Valve - Replacement - Miele W1903 User Manual

W1900 Series Clothes Washers
5.6 Heater Element(s) – Replacement
1. Open the Front Service Panel – Refer to Section 5.3.
2. Ensure the unit is unplugged.
3. Note wiring connections to the heaters. Unplug the electrical
connections to the heater(s).
4. Pull straight out on the Heater Element to remove.
5. Install new seals and ground rings to each new element. Apply a thin
film of soap solution to lubricate the seals and fit the elements into
position.
6. Attach the electrical connection(s) to each heater.
Service Tip:
Ensure the element is inserted under its retaining clip.
Retaining Clip Inside Suds Container

Figure 5-5: Heater Element

5.7 Inlet Valve – Replacement
1. Turn off the water supply to the appliance.
2. Remove the Water Inlet Hose from the Valve.
3. Remove the top cover from the appliance – Refer to Section 5.2.
4. Loosen the hose clamps.
Service Tip:
Ensure the hoses on the Cold Water Valve are re-connected in the
correct locations – mark hoses as necessary.
5. Remove each hose (1 by 1) and attach to the new Valve.
6. Remove the screw(s) on the rear panel of the washer, lift old Valve
Assembly from machine to remove.
39
Technical Information