Honda Motorcycle User Manual page 65

Engine Oil u Changing Engine Oil & Filter
6. Remove the oil filter with a filter wrench
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
u Discard the oil and oil filter at an
approved recycling centre.
Oil filter
62
7. Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8. Install a new oil filter and tighten.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft).
9. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Rubber
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft).
seal
10. Fill the crankcase with the recommended
oil (
Required oil
11. Check the oil level.
12. Check that there are no oil leaks.
P. 45) and install the oil fill cap.
2
When changing oil &
engine oil filter:
3.9 litres (4.1 US qt, 3.4 Imp qt)
When changing oil only:
3.8 litres (4.0 US qt, 3.3 Imp qt)
P. 59
2