Display; Channel Setting - Sony MB-X6 User Manual

e CH (channel) button
To change the channel within the same group, press the +
button or – button while holding down this button.

Display

RF
a AF (audio frequency) indicator/AF level
indications
When the audio output level is higher than the reference
level, this indicator lights up and the indications appear.
b BATT (battery) indicator/BATT indication
This indicator starts to flash and the indication appears and
also starts flashing about one hour before the battery with
alarm function used with the transmitter becomes empty.
The time at which flashing begins will depend on the type
of battery used with the transmitter and its condition.
c GP/CH (group/channel) indication
Shows the reception channel group and the channel
number. Pressing the + button changes this indication to
the frequency indication.
d RF (radio frequency) indicator/ RF level
indications
When the antenna reception is optimal, this indicator lights
up and the indications (dots) appear. The number of dots
changes reflecting the RF input level.

Channel setting

Take the following precautions to prevent interference and
noise.
• If there is a TV broadcasting station nearby, to avoid
possible interference from its broadcasting, do not use
that station's channel.
• When simultaneously using two or more tuners, always
set the tuners to different channels within the same group
(other than group 00).
12
About the WRU-806A/WRU-806B UHF Synthesized Tuner Unit
AF BATT
GP CH
1
Press the POWER switch on the MB-X6 to turn it on.
The model version number such as "U66" appears in
the display of the tuner unit, and then the setting which
has been made right before the MB-X6 was turned off
is displayed.
2
Press and hold down the GP button, and press the + or
– button to select a group.
Each time you press the + or – button, the GP
indication changes as shown in the figure below. To
change the indication continuously, press and hold
down the + or – button.
GP CH
Display example: WRU-806B (U66 model)
The CH indication shows the lowest frequency
channel of the selected group. For group 00, however,
the channel selected last is displayed.
Releasing the buttons automatically cancels the group
and channel selection mode, and the currently
displayed group is selected.
3
Press and hold down the CH button, and press the + or
– button within 3 seconds to select the channel.
Similar to step 2, each time you press the + or – button,
the CH indication changes in the order shown in the
group and reception channel list.
If you press the + button when the last channel of the
selected group is displayed, the first channel of the
group will be displayed.
GP CH