Table of Contents
Advertisement
Symptom
● Stamped images are
not clear.
● A sheet holder is
jammed and won't
come out.
Specifi cations
Model:
Printing
Printing method:
Printing resolution:
Maximum printing width: Approximately 45 mm (1
Maximum printing length: Approximately 90 mm (3
Supported types:
Power Supply, Other
Operation power supply: AC adaptor
Rated voltage:
Rated consumption current: 1 A (12 W)
Dimensions:
Weight:
Operating temperature:
Cause and Required Action
• Stamping certain types of paper may result in unclear
images.
➜ Refer to "Supported paper types" (page 12).
Referring to "If a sheet holder becomes jammed" (page
31), pull out the sheet holder.
Next, return the release lever to the PRINT side and
perform printing again. If you experience problems using
the same sheet holder, use a new one.
Important!
Note the following while printing is in progress.
• Do not allow the sheet holder outlet slot to become
covered.
• Do not touch the sheet holder.
• Do not change the release lever position.
• Do not disconnect or unplug the AC adaptor.
STC-U10
Fusion melting by thermal head
• Stamp type: Permeation-type stamp
200 dpi
15 mm × 15 mm (
3
/
3
15 mm × 60 mm (
/
30 mm × 60 mm (1
45 mm × 90 mm (1
AD-A12200L (supplied)
12V DC
82 mm (W) × 123 mm (D) × 59.5 mm (H) (3
(Including rubber feet.)
Approximately 305 g (10.76 oz.)
10°C to 35°C (50°F to 95°F)
47
3
/
")
4
1
/
")
2
" ×
3
/
"), 15 mm × 30mm (
5
5
3
" × 2
/
"), 30 mm × 30 mm (1
5
8
1
3
/
" × 2
/
"), 45 mm × 45 mm (1
6
8
3
/
" × 3
1
/
")
4
2
3
/
" × 1
1
/
"),
5
6
1
1
/
" × 1
/
"),
6
6
3
3
/
" × 1
/
"),
4
4
1
13
5
/
" × 4
/
" × 2
/
")
4
16
16
Advertisement
Table of Contents
