Step 17 Adjust Decorative Panels; Step 18 Replace Trim - GE Side by Side Refrigerators Installation Instructions Manual

STEP 17 ADJUST DECORATIVE PANELS

- FLUSH INSTALLATION ONLY
(Cont)
5. Make the final vertical adjustment of the fresh food
and freezer door panels. Using the set screw at the
top of the door, turn clockwise until the desired gap
between the grille panel bottom and top panels of
doors appear satisfactory.
Turn set screws on top and bottom
of door to move panel up or down
for desired gap with grille panel
bottom.
6. Tighten all washer-head screws (NOT SET SCREWS)
firmly to secure brackets and adjustments in place.
Start with bottom edge washer-head screws to
provide support of the door panel. Next, moving on to
top edge to prevent panel from moving from aligned
position. Finish by tightening hinge side washer-head
screws. NOTE: Over tightening washer-head screws
may result in bending wood panel brackets as well as
misaligning wood door
panels.
7. Drive the door anchor
screws through the
two white plastic
pockets in the side of
each door and into
the door panel (4 each
door) to prevent panel
warping over time.
Installation Instructions
25
STEP 18 REPLACE TRIM - FLUSH
INSTALLATION ONLY
1. Replace trim and 6 screws on hinge side of each door.
2. Replace handle visor trim and four screws on the
handle side of each door.
3. Replace trim cover and four screws over visor trim on
the handle side of each door.
Hinge side
trim
Handle
visor trim
Handle
side trim
Hinge side
trim