Mobile Home Installation; Unpacking; Reversing Door Swing - Electrolux 6000 Service Manual

MOBILE HOME INSTALLATION

1. Dryer MUST be exhausted outside (outdoors, not
beneath the mobile home) using metal ducting that
will not support combustion. Metal ducting must
be 4 inches (10.16 cm) in diameter with no
obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area
beneath the mobile home is enclosed, the exhaust
system MUST terminate outside the enclosure
with the termination securely fastened to the mobile
home structure.
3. When installing a gas dryer into a mobile home, a
provision must be made for outside make up air.
This provision is to be not less than twice the area
of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile
Home Installation Kit No. 346764 is available from
your dealer.
5. Refer to other important venting requirements.
6. Installation MUST conform to current Manufactured
Home Construction & Safety Standard (which is a
Federal Regulation Title 24 CFR-Part 32-80) or when
such standard is not applicable, with American
National Standard for Mobile Homes.
The dryer is designed under ANSI Z
21.5.1or ANSI/UL2158 - CAN/CSA C22.2 (latest
editions) for HOME USE only.

UNPACKING

1. Using a rug, blanket or a piece of cardboard packing to
protect the floor, carefully lay the dryer on its left side
and remove the foam shipping base.
To prevent damage, do not use the control
panel as a means to pick up or move the dryer.
2. Return the dryer to an upright position.
DRYER DOOR REVERSAL INSTRUCTIONS
1. Open the dryer door.
34
FOAM
SHIPPING
PAD
PACKING