Mobile Home Installation - Electrolux AEQ6000ES Installation Instructions Manual

MOBILE HOME INSTALLATION
1 Dryer MU5T be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not
support combustion Metal ducting must be 4 inches
(10.16 cm) in diameter with no obstructions Rigid metal
duct is preferred
2 If dryer is exhausted through the floor and area beneath
the mobile home is enclosed, the exhaust system MUST
terminate outside the enclosure with the termination
securely fastened to the mobile home structure.
3 When installing a gas dryer into a mobile home, a
provision must be made for outside make up air This
provision is to be not less than twice the area of the dryer
exhaust outlet
4 This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No 346764 is available from your dealer.
5 Refer to pages 2 and 3 for other important venting
requirements
6 Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal
Regulation Title 24 CFR-Part 32-80) or when such
standard is not applicable, with American National
Standard for Mobile Homes
The dryer is designed under ANSI Z 21.5.1 or
ANSI/UL2158 - CAN/CSA C222 (latest editions) for HOME
USE only.
UNPACKMNG
1. Using a rug, blanket or a piece of cardboard packing to
protect the floor, carefully lay the dryer on its left side and
remove the foam shipping base
2. Return the dryer to an upright position
FOAM
SHIPPING
DO
Correct
incorrect