Frigidaire Dryer Servicing page 45

Error Codes - Gallery Series
Reading Error Codes - Gallery Series
1. Non-Digital Readout Display Models: Rotate cycle selector knob to the 3 O'clock position.
Digital Readout Display Models: Rotate cycle selector knob clockwise (3) settings from the Normal cycle option.
2. Press and hold the Select and Pause Cancel buttons simultaneously for six seconds.
3. Immediately after, press and hold the START and Pause Cancel buttons simultaneously for 4 seconds.
4. Digital Readout Display Models: rotate the timer knob (1) click counterclockwise. The error code will appear in the
digital display.
Non-Digital Readout Display Models: rotate the cycle selector knob to the 2 O'clock position. The four indicator
lights of Drying, Cool Down, Wrinkle Rid (Press Saver), and Clean Lint Filter will flash the number of times for the
first digit of the code and the START indicator light will flash the number of times for the second digit. Take
separate counts of each indicator light, then repeat to confirm in order to be accurate in identifying the proper
error code. The code is obtained by counting the number of times the lights flash.
Example E24: The four indicator lights would flash twice indicating the 2 and the START indicator light will flash
four times indicating the 4. The four indicator lights and the START indicator light start flashing at the same time.
The control will pause for 2 seconds, then repeat the code.
NOTE
A letter appearing in the code stands for a number higher than nine. A = 10, B = 11, C = 12, D = 13, E = 14,
F = 15. Example Code E4A: the first digit would be 4 and the second digit would be 10. If this code would appear
on a washer in the Non-Digital Readout Display Models, the four indicator lights would blink four times and the
START indicator light would blink ten times.
Troubleshoot the problem by using the chart on page 3-15.
To move on to the next code, press the OPTIONS button.
To clear code, press the Select button. Code will be cleared when mode is exited.
To exit this mode, simultaneously press and hold the Select and Pause Cancel buttons for six seconds.
Section 3 Electronic Control
3-13