Advertisement
Quick Links
REAR WHEEL DRIVE BIKE ASSEMBLY
INTRODUCTION
KEISER CORPORATION has always taken pride in designing and engineering the
highest quality equipment on the market. This means that you will receive years of low
maintenance and minimal repairs from every one of our bikes. Only the highest quality
products have the KEISER name on them.
This manual was written with the customer in mind. It will assist you in the assembly of
the KEISER Rear Wheel Drive Bike. Since we always find ways to improve our
products, parts and machine designs are subject to change without notice. If you have any
questions, please call our service department at (800) 888-7009.
WORD DEFINITIONS
SAFETY CAUTIONS and WARNINGS:
We've put a number of safety cautions in this book. We use the word Caution! to tell you
about things that could cause bodily injury to persons on or around the equipment if you
were to ignore the following instructions, and the word Warning! to ensure the proper
installation of components and that the instructions are followed for the safety of the
users and for maximum machine life or the warranty is void.
HINTS:
We use the word Note! in this book to tell you about things that we recommend you
doing or things to be aware of before performing the instructions. These notes were
placed in the manual to aid you during a certain procedure.
Caution
The unit should only be operated with the chain cover guard fitted
correctly, as supplied. Children in the area and users are vulnerable to
injuries to fingers if the unit is used without the chain cover guard.
Warning!
Failure to follow the assembly or operation instructions as provided by this
manual or any other instructions pertaining to the assembly and/or
operation of KEISER equipment will result in voiding the warranty and
could lead to serious injury.
Advertisement
Related Manuals for Keiser REAR WHEEL DRIVE BIKE
Summary of Contents for Keiser REAR WHEEL DRIVE BIKE
- Page 1 This manual was written with the customer in mind. It will assist you in the assembly of the KEISER Rear Wheel Drive Bike. Since we always find ways to improve our products, parts and machine designs are subject to change without notice. If you have any questions, please call our service department at (800) 888-7009.
- Page 2 KEISER Rear Wheel Drive Bike ASSEMBLY INSTRUCTIONS Tools needed for assembly: Torque wrench (0-90 ft-lbs.) 5/8 inch open-end wrench #2 Phillips screwdriver Paste or Spray wax (not provided) Clean cloth A. Unpack 1. Remove the following contents from the packing box:...
- Page 3 Step Two Step Four Step Three Step Five Step One Step One Step One: Mount Main Frame on Base Frame Tools required: four bolts, eight washers, and four acorn nuts, torque wrench, 5/8” wrench, 5/8” socket Place the four washers on the bolts, and place the bolts in the holes on the base frame. Put a stack of cardboard between the bolts and the floor.
- Page 4 The Base Frame has a front and rear. The rear of the Base Frame has caster wheels. Place the Main Frame behind the Base Frame; use the flywheel to roll the Main Frame up onto the Base Frame. The flywheel should be situated between the rear caster wheels. rear Start one bolt by placing a washer and then the acorn nut loosely onto the bolt.
- Page 5 handle bar faces outward cover screw neck cover cover screw cover screw dowels cover screw Pull the handle bar up, and then use the paper clip to insert the longer of the two dowels in the same hole as the first dowel. Replace the plastic cover on the neck and make sure the cover is snapped in correctly before replacing the four screws.
- Page 6 or crossing the threads will ruin the crank arms and void the warranty. In no case should the pedals be left loose on the crank arms as the pedals may pull out of the crank arms damaging them and causing serious injury Apply Loctite 242 Place the Loctite 242 on the thread of the second pedal, place it on the right-hand crank arm, tighten clockwise finger tight, and finish with a torque wrench by tightening to 35 ft-lbs...
- Page 7 Service Department (800) 888-7009...