Cleaning The Filters; Cleaning The Spray Arms - Baumatic BDW65S Instruction Manual

Cleaning the filters

For best performance and results, the entire filter assembly should be
thoroughly cleaned regularly.
1. Turn the coarse filter anti-clockwise and then lift it upwards.
Rinse the filter sections under a tap to remove any food debris
that remains in them.
2. Replace all three of the filters into their original positions. You
must turn the coarse filter clockwise to lock it back into position.
IMPORTANT: If a glass gets smashed inside of the appliance,
you must check there is no glass in the filter before the
machine is used again as this can cause a drainage failure.
IMPORTANT: THE DISHWASHER SHOULD NEVER BE
SET ON A WASH CYCLE WITHOUT THE FILTERS BEING
INSIDE OF THE APPLIANCE.

Cleaning the spray arms

The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
arms back in their original positions.
o To remove the upper spray arm,
hold the nut and rotate the arm
clockwise to remove it.
o To remove the lower spray arm,
gently pull it upwards.
o Wash the spray arms in warm,
soapy water and use a soft brush
to clean the jets.
o Rinse the spray arms thoroughly
and then reassemble the spray
29