Boot Menu - Fujitsu 1PRIMERGY RX600 S4 User Manual

Chapter 7 Configuring Hardware and Utilities
Item
LAN Settings
Management LAN
Service LAN Port
DHCP
Local IP Address
Subnet Mask
Gateway Address
IPMI Status

7.2.19 Boot Menu

This menu is for specifying the priority order of startup. The names of CD devices and hard disk drive
devices on the screen vary depending on the onboard devices.
Main Advanced
1 : IDE 2 : DV-28S-V-(S1)
2 : PCI SCSI : (Bus 16 Dev 00) PCI RAID Ad
3 :
4 :
5 :
6 :
7 :
8 :
: Legacy Network Card
: Alternate Device
Info
F1
Exit
Esc
178
table: IPMI submenu
Setting
This is for LAN settings of the Remote Management Controller port.
Set this when performing the remote operation by using RemoteControlService.
Press the [Enter] key to display the [LAN Settings] screen.
• Disabled
• Enabled (Initial value)
Service (Unchangeable)
• Disabled (Initial value)
• Enabled
[000.000.000.001]
[000.000.000.000]
[000.000.000.000]
Displays IPMI information.
Press the [Enter] key to display the [IPMI Status] screen.
Phoenix TrustedCore(tm) Setup Utility
Security Power
-/+ Change Values
Select Item
Select Menu Enter Select
Description
Sets whether to enable the Remote Management
Controller port.
This setting is for Service LAN.
Sets whether to obtain a LAN IP address of the Remote
Management Controller port from the DHCP server.
When "Disabled" is set, IP address setting can not be set.
Enter the IP address, the subnet mask, and the default
gateway of the Remote Management Controller port.
Exit
Server Boot
Item Specific Help
F9 Setup Defaults
Sub-Menu F10 Save and Exit