Table of Contents
Advertisement
set ip ethernet A ip_address
consists of two keywords (
mand to configure your Gateway, you would replace the argument with a value appropriate to your site.
For example:
set ip ethernet A 192.31.222.57
Guidelines: CONFIG Commands
The following table provides guidelines for entering and formatting CONFIG commands.
Command
component
Command verbs
CONFIG commands must start with a command verb (set, view, delete).
You can truncate CONFIG verbs to three characters (set, vie, del).
CONFIG verbs are case-insensitive. You can enter "SET," "Set," or "set."
Keywords
Keywords are case-insensitive. You can enter "Ethernet," "ETHERNET," or "ethernet" as a
keyword without changing its meaning.
Keywords can be abbreviated to the length that they are differentiated from other key-
words.
Argument Text
Text strings can be as many as 64 characters long, unless otherwise specified. In some
cases they may be as long as 255 bytes.
Special characters are represented using backslash notation.
Text strings may be enclosed in double (") or single (') quote marks. If the text string
includes an embedded space, it must be enclosed in quotes.
Special characters are represented using backslash notation.
Numbers
Enter numbers as integers, or in hexadecimal, where so noted.
IP addresses
Enter IP addresses in dotted decimal notation (0 to 255).
If a command is ambiguous or miskeyed, the CLI prompts you to enter additional information. For example, you
must specify which virtual circuit you are configuring when you are setting up a Motorola Netopia® Gateway.
Displaying Current Gateway Settings
view
You can use the
command to display the current CONFIG settings for your Motorola Netopia® Gateway. If
view
you enter the
command at the top level of the CONFIG hierarchy, the CLI displays the settings for all
enabled functions. If you enter the
subnodes.
Step Mode: A CLI Configuration Technique
The Motorola Netopia® Gateway command line interface includes a step mode to automate the process of enter-
ing configuration settings. When you use the CONFIG step mode, the command line interface prompts you for all
required and optional information. You can then enter the configuration values appropriate for your site without
having to enter complete CLI commands.
When you are in step mode, the command line interface prompts you to enter required and optional settings. If a
setting has a default value or a current setting, the command line interface displays the default value for the com-
mand in parentheses. If a command has a limited number of acceptable values, those values are presented in
brackets, with each value separated by a vertical line. For example, the following CLI step command indicates that
off
the default value is
ip
,
ethernet A
and
Rules for entering CONFIG commands
view
command at an intermediate node, you see settings for that node and its
and that valid entries are limited to
) and one argument (
ip_address
on
off
and
.
). When you use the com-
65
Advertisement
Table of Contents
