Debug Platform Dot1X - Cisco Catalyst Blade Switch 3130 Reference Manual

debug platform dot1x

debug platform dot1x
Use the debug platform dot1x privileged EXEC command to enable debugging of IEEE 802.1x events.
This command enables debugging of stack-related IEEE 802.1x events. Use the no form of this
command to disable debugging.
Syntax Description
initialization
interface-configuration
rpc
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines
The undebug platform dot1x command is the same as the no debug platform dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-32
debug platform dot1x {initialization | interface-configuration | rpc}
no debug platform dot1x {initialization | interface-configuration | rpc}
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
Display IEEE 802.1x-authentication initialization sequence debug
messages.
Display IEEE 802.1x interface configuration-related debug messages.
Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
OL-13271-01