Dell DCT User Manual page 6

0Y0561.book Page 4 Thursday, May 8, 2003 9:45 AM
green retention
base screws (4)
4
Replacing the System Board
Heat-sink fan shroud
d
Heat sink
e
Chassis intrusion switch
f
Remove the heat-sink retention base by removing the four green
9
screws that secure the retention base to the chassis.
Remove the five silver screws that secure the system board to the
10
chassis.
NOTICE: The module device connector is attached underneath the system
board. When removing the system board, be careful not to bump or catch the
connector on the metal chassis floor.
silver system board
screws (5)