Outputting A Control Signal To An External Device In Tandem With Scene Recall (Gpi Out) - Yamaha QL5 Reference Manual

FADE TIME window
You can select the channels to which Fade will be applied, and adjust the fade time. To display
this window, press the SET button in the FADE TIME field in the SCENE LIST window.
1
1
Channel display field
The channels or DCA groups to which Fade is applied are highlighted. To select the
channels or DCA groups to which Fade is applied, press the [SEL] keys for the channels
or DCA groups. Press the same [SEL] key once again to de-select the channel.
2
FADE TIME knob
Sets the fade time. You can use the [TOUCH AND TURN] knob to adjust the values.
The range is 0.0 sec – 60.0 sec.
NOTE
The fade time is used for all channels and DCA groups selected in the channel display field.
3
SET ALL button
Press this button to apply the Fade effect to all faders of that scene.
4
CLEAR ALL button
Press this button to cancel the Fade function for all faders of that scene.
NOTE
In the case of the QL1, faders that do not exist on the model will not be shown.
3 4
2
Outputting a control signal to an external device
in tandem with scene recall (GPI OUT)
A control signal can be output to an external device connected to the GPI connector of the QL
series console when you recall a specific scene. Proceed as follows.
NOTE
For more information on GPI OUT settings, refer to
STEP
1. Press the SCENE field in the Function Access Area.
2. Press the GPI OUT tab at the bottom of the SCENE LIST window.
3. For each scene, specify the control signal that you want to output to each GPI OUT
port.
4. Recall the scene for which you want to output GPI OUT signals.
SCENE LIST window
(GPI OUT field)
83
Scene memory
"Using GPI OUT" on page 204.
Reference Manual