Makita 6940D Instruction Manual page 8

Installing or removing the bit
IMPORTANT :
Always be sure that the machine
is
switched off and the battery cartridge
i s
removed
before installing or removing the bit
To install the bit, pull the sleeve in the
direction of the arrow and insert the
bit into the sleeve
as
far
as it
will go.
Then release the sleeve to secure the bit.
To remove the bit, pull the
sleeve
in the
direction of the arrow and pull the bit out
firmly.
Adjusting the angle head
IMPORTANT :
Always be sure that the machine
i s
switched off and the battery cartridge
i s
removed
before adjusting the angle head.
The angle head can be adjusted 360" (8 positions in 45-degree increments). To adjust it,
loosen the hex bolt and remove the angle head. Adjust the angle head to the desired posi-
tion and reinstall it
so
that the teeth on the housing will match up with the grooves in the
angle head. Then tighten the hex bolt to secure the angle head.
Hex bolt
- \
Angle head
2
rG
Tooth
8