Logout; Ping - D-Link DGS-1500-20 Reference Manual

6 Command Line Interface
Restrictions
Example usage:
To configure the IP interface System:
DGS-1500-28> config ipif System ipaddress 10.48.74.122/8
Success.
DGS-1500-28>

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:
DGS-1500-28> logout

ping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.90.90.91:
ipv6 ipv6address <ipv6networkaddr> − Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a network prefix length.
Multiple IPv6 addresses can be configured for a single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the
prefix length of the IPv6 addresses.
dhcpv6_client <enable | disable> − Specify the DHCPv6 client to
be disabled or enabled.
None.
To log out a user from the Switch's console.
logout
The logout command terminates the current user's session on
the Switch's console.
None.
None.
NOTE: Save your configuration changes before
logging out.
To test the connectivity between network devices.
ping <ip_addr>
The ping command checks if another IP address is reachable on
the network. You can ping the IPv4 address connected to through
the managed VLAN (VLAN 1 by default), as long as there is a
physical path between the switch and the target IPv4 equipment.
By default, Switch sends five pings to the target IP.
<ip_addr> - The IPv4 address of the host.
None.
9 9
9 9
D-Link Web Smart Switch User Manual