.
WARNING!
4.7 Using the RFS4010 RF Switch Reset Button
The RFS4010 RF Switch has a reset button on the rear of the switch near the power connector.
To reset the switch to factory defaults:
1. Connect a computer to the Console Port as outlined in
Console Port Setup
2. Reset the switch using the Web UI or the Command Line Interface.
An improper shutdown can render the RFS4010 RF Switch inoperable
such that it could require service by Motorola Support. Do not remove AC
power without first following the shutdown procedure. An abrupt loss of
power can corrupt the information stored on the device.
Hardware Setup
Reset Button
Chapter 4.5, RFS4010 RF Switch
19