Configuring Traffic Flows - Cisco RV 120W Administration Manual

Configuring Quality of Service (QoS)

Configuring Traffic Flows

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Configuring Traffic Flows
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV 120W Administration Guide
Add Profiles
In the Bandwidth Profiles Table, Click Add.
Enter the Profile Name, or the name used to identify and associate the profile to
traffic selection criteria.
Choose the Profile Type: priority (to limit bandwidth by high, medium, or low
priority) or rate (to limit bandwidth by the transmission rate.
If you chose priority, enter the priority for this profile (low, medium, or high). If you
chose rate, enter the minimum and maximum bandwidth rates in kilobytes per
second.
Click Save.
After a profile has been created, it can then be associated with a traffic flow. To
create a traffic selector:
Choose QoS > Traffic Selectors.
In the Traffic Selectors Table, click Add.
Choose the bandwidth profile which will applied to this traffic. (See
Bandwidth Profiles, page
Choose a service from the list. Traffic flow rules will be applied to this service. (If
you do not see a service that you want, you can configure a custom service in the
Firewall page - see Creating Custom Services, page
In the Traffic Selector Match Type field, choose the type of matching the
bandwidth profile will use before applying the traffic flow rules:
• IP Address Range—Enter the starting and ending IP address ranges.
• MAC Address—Enter the MAC address.
• Port Name—Select the port on the router to which traffic rules will be
applied.
• VLAN—Select the VLAN on the router to which traffic rules will be applied.
120.)
6
Configuring
84.)
121