Network Setting - Pioneer X-HM81-S Operating Instructions Manual

8
8

Network setting

If a broadband router (with built-in DHCP server function) is
connected to this receiver, you can simply turn on the DHCP
server function without having to set up the network
manually. A broadband router without a DHCP server
function connected to this receiver must be set up as
described below. Before you set up the network, consult with
your ISP or the network manager for the required settings.
It is advised that you also refer to the operation manual
supplied with your network component.
Any changes made to a router without the DHCP server
function must be reflected to receiver network settings.
1
Press NETWORK  SETUP.
The Initial Setup screen is shown on the display.
2
Select Network Setting  Network Configuration.
3
Use / to select Wired or Wireless, then press ENTER.
Network Configuration
Wired
Wireless
Next steps are described separately between Wired Setting
and Wireless Setting. Follow the instructions of the
appropriate network type.
24
Wired setting
Make sure that the LAN cable connections has completed
(page 10).
1
Use / to select DHCP On, then press ENTER.
Select Use Proxy Server to setup Proxy Host Name and
Proxy Port.
Network Configuration
DHCP On
DHCP Off
If your router does not have a built-in DHCP server
function, you have to set up the network manually. Return
to step 1 and select DHCP to be Off and press ENTER.
When you select DHCP to be Off, go to step 2.
2
Use /// or numeric buttons to adjust the
numbers, then press ENTER.
IP Address
255 . 255 255
.
/: Moves the adjusting digit.
/: Increases or decreases values.
IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet radio
stations.
Class A: 10.0.0.1 to 10.255.255.254 / Class B: 172.16.0.1 to
172.31.255.254 / Class C: 192.168.0.1 to 192.168.255.254
Subnet Mask
If an xDSL modem or a terminal adapter is directly
connected to this receiver, enter the subnet mask listed in
your ISP documentation. In most of the cases, enter
255.255.255.0.
Default Gateway
If a gateway (router) is connected to this receiver, enter
the corresponding IP address.
Primary DNS Server/Secondary DNS Server
If there is only one DNS server address listed in your ISP
documentation, enter Primary DNS Server. In case there
are more than two DNS server addresses, enter
Secondary DNS Server in the other DNS server address
field.
Proxy Setup
Select Use Proxy Server when you connect this receiver
to the Internet via a proxy server. Enter Proxy Host Name
and the port number of your proxy server in the Proxy
Port field.
Wireless Setting
1
Use / to select Auto, then press ENTER.
255
.
If you setup manually, select Manual.
Internet radio
Wireless
Auto
Manual
Web Control
iOS Device