Table of Contents
Advertisement
ED
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
By adjusting the remote signal, you can control
your TV, a Sony component (such as a VCR,
DVD player/recorder, etc.), CATV, or set-top
box/digital satellite receiver with the supplied
remote.
-
Code number
TV
Manufacturer
1
Press pOP UP/MENU while pressing
TV (for TV) or STB (for a Sony
component, CATV, set-top box/digital
satellite receiver, etc.).
TV or STB (pressed button) flashes.
2
While TV or STB is flashing, enter the
manufacturer's code (see the table)
using the number buttons, then press
TIME.
If you successfully set the manufacturer's
code, TV or STB will flash twice slowly. If
the setting is unsuccessful, TV or STB will
flash five times quickly.
Code numbers of controllable
components
If more than one code number is listed, try
entering them one at a time until you find the
code that works with your TV.
Controlling the TV or
Other Components with
the Supplied Remote
• [Test Tone]
The speakers will emit a test tone to adjust
[Level].
[Front L/R] 0.0 dB: Set the front speaker level.
[Center] 0.0 dB*: Set the center speaker level.
[Surround L/R] 0.0 dB*: Set the surround
speaker level.
[Surround Back LlR] 0.0 dB*: Set the surround
Back speaker level.
[Subwoofer] 0.0 dB: Set the subwoofer level.
*
This item appears when you set to [Yes] in the
[Connection] setting.
[Off]: The test tone is not emitted from the
speakers.
[On]: The test tone is emitted from each speaker
in sequence while adjusting level. When you
select one of the [Speaker Settings] items, the
test tone is emitted from each speaker in
sequence.
Adjust the sound level as follows.
1
Set the [Test Tone] to [On].
2
Press
+-I't/~I-+
repeatedly to select the
desired speaker and the level.
3
Press
0.
4
Repeat Steps 1 to 3.
5
Press
+-/'t/~I-+
repeatedly to set [Test
Tone] to [Off] after adjusting the
speaker level.
• [Level]
You can adjust the sound level of the speakers,
center speaker, and subwoofer. You can set the
parameters from -6.0 dB to +6.0 dB. Be sure to
set [Test Tone] to [On] for easy adjustment.
ED
• When you perform [Auto Calibration] in the Easy
Setup (page 60), the default settings are changed.
• Depending on the input stream, [Distance] may not
be effective.
ED
• The test tone signals are not output from the HDMI
OUT jack.
SONY
AIWA
AKAI
5001 (default), 5002
5001
5003
mI
• To adjust the volume of all the speakers at one time,
press VOLUME +/-.
DAEWOO
GE
GOLDSTARlLG
5003, 5015, 5044
5003,5009,5010,5044
5003,5015,5017,5044,5068
101
US
Advertisement
Table of Contents
