Install Range Hood - KitchenAid 30" Installation Instructions And Use & Care Manual

13. Place the vent hood on its back side on a protected surface.
Slide the screen forward. Pull the tabs to remove the filters.
Remove the terminal box cover. Close the screen. Slide the
mounting brackets to the top position.
A
A. Terminal box cover.
NOTE: For some installations using the recirculating kit, it
may be easier to attach the vent system to the hood before
lifting the hood into its final position. Seal the connection with
duct tape.

Install Range Hood

WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Lift the vent hood into its final position and feed the electrical
wire through the wiring opening. The mounting brackets
should overlap the cabinet bottom or wood filler strips.
Center the range hood.
B
C
A. Mounting bracket
B. Cabinet bottom
C. Optional wood filler strip
D. Vent hood
10
A
D
2. Check that the front panel is parallel with the cabinet front
when the screen is pushed in. Slide the screen forward.
Tighten the mounting bracket screws so that the vent hood is
secured to the cabinet.
A
A. Mounting bracket screw
B. Flat-blade screwdriver
3. Align the hood front panel with the cabinet. Slide the screen
forward. Locate the 2 screws on each side and turn them
counterclockwise to loosen the screws. Adjust the front of the
vent vertically, ³⁄₈" (9.5 mm) up or down, or horizontally,
³⁄₄" (19 mm) front to back, until the front is flush with the
cabinet. Tighten the screws. If it is necessary to adjust the
given dimensions, lower and add or remove the filler strips or
redrill mounting holes.
B
A. Phillips screwdriver
B. Adjustment screws
B
A