GE 3-5377 User Manual
GE 3-5377 User Manual

GE 3-5377 User Manual

Microcassette recorder

Advertisement

u s e r m a n u a l
3-5377
Microcassette
Recorder

Advertisement

Table of Contents
loading

Summary of Contents for GE 3-5377

  • Page 1 3-5377 Microcassette Recorder...
  • Page 2: Fcc Information

    FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. In accordance with FCC requirements, changes or modifications not expressly approved by Thomson Inc.
  • Page 3: Headset Safety

    Headset Safety • Do not play your headset at a high volume. Hearing experts advise against continuous extended play. • If you experience a ringing in your ears, reduce volume or discontinue use. • Do not use while operating a motorized vehicle or bicycle, it may create a traffic hazard and is illegal in many areas.
  • Page 4: Powering The Recorder

    Powering the Recorder Battery Installation 1. Open hinged battery door by pressing down just above the arrow, sliding it as indicated and lifting up. Note that to avoid damage to the battery door, do not attempt to force door beyond its normal stopping point.
  • Page 5: Using The Recorder

    Using the Recorder Insert or Remove a Microcassette 1. Press the STOP EJECT button to stop recorder or to open cassette carry door and remove microcassette. Note that when in play or record mode you must press STOP EJECT once to turn player off and again to open the cassette carry door.
  • Page 6: Record With An External Microphone

    Using the Recorder Mic Sensitivity Switch This two-position switch enables selection between two microphone sensitivity levels: • HI —for maximum sensitivity for conferences or general use. • LO —for a lower sensitivity level for dictation purposes. Record Records continuously when the recorder is in the RECORD mode. 1.
  • Page 7: Tape Speed

    Using the Recorder Automatic Voice Activated Recording Switch (avr) The AVR feature allows the recorder to sense sound and to record only when you are speaking into the microphone. When dictation stops for approximately 6 seconds, tape operation will stop. Recording will start again when you resume dictation.
  • Page 8 Using the Recorder Tape Play To listen to your recorded microcassette, rewind to the starting point and press STOP/EJECT button. Press PLAY and adjust the VOLUME to desired listening level. IMPORTANT: Tapes must be played back at the same speed in which they were recorded.
  • Page 9: Care And Maintenance

    Care & Maintenance Tape Erase To erase a tape simply record over the unwanted recording. Erase Protection When you record new material, the cassette deck records over whatever is on a tape. To protect a tape from accidental erasure, break off one or both plastic tabs (one for each tape side) on the side of the cassette tape.
  • Page 10 U.S. Limited Warranty What your warranty covers: • Defects in materials or workmanship. For how long after your purchase: • One year from date of purchase. The warranty period for rental units begins with the first rental or 45 days from date of shipment to the rental firm, whichever comes first.
  • Page 11: Canadian Limited Warranty

    Canadian Limited Warranty Thomson multimedia Ltd. warrants to the purchaser or gift recipient that if any manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation.
  • Page 12 ©2004 Thomson Inc. Comercializadora Thomson de Mexico, S.A. de C.V. Trademark(s) © Registered Miguel de Cervantes Saavedra 57 Marca(s) © Registrada(s) Col. Ampliacion Granada Marque(s) © Deposée(s) C.P. 11529 Mexico D.F. 55880350 (EN/E/F) Telefono: (55) 25 81 53 20 www.ge-electronics.com R.F.C.: CTM-980723-KS5...

Table of Contents