Handling A Cd/Dvd - AEG AR 4023 DVD Instruction Manual

ENGLISH
36
Fault Symptoms Cause
CD works The CD is dam-
intermittently aged.
(dropouts).
The CD is dirty.
The device
may have been
installed in the
vehicle at the
wrong angle.
No function. The ignition is
switched off.
Device cannot Incorrect con-
be switched on nection (each car
or off via the manufacturer
ignition. wires the ISO
connection in the
vehicle differ-
ently).
The device The microcom-
does not work puter has been
correctly (EJECT, interfered with by
LOAD, PLAY). electromagnetic
fields.
The device can- The control
not be operated, processor of the
but "hangs up". device may have
been blocked
by overvoltage
or undervoltage
in the vehicle
electrical system.
No radio recep- The antenna cable
tion. is not connected.
Poor radio It is possible that
reception. your vehicle has
a special antenna
(phantom-pow-
ered antenna.)
In automatic The transmission
search mode the signals are too
radio does not weak.
stop at a trans-
mitting station.
Solution Fault Symptoms Cause
Try another CD. If DVD cannot be
this works correctly, played.
the first CD is prob-
Audio or Video
ably damaged.
interference
Clean the CD. from video files
which are played
Please note that a
back via USB or
maximum inclina-
memory card.
tion of 20° degrees
should not be
exceeded!
Turn the ignition key

Handling a CD/DVD

to "ON" or "ACC".
Cleaning the CD
Replace the fuse by
another 15 A fuse.
Please contact your
car workshop or a
vehicle specialist for
connection adapters
may specifically for
or thinning agents. commercially available cleaning sub-
your model.
stances or antistatic sprays will damage the device.
Inserting the CD
Remove the CD and
insert it again.
Switch the device
off and on again.
Press the RESET but-
ton.
not try to insert a second cd. this may damage the
device.
Touching the CD
Insert the antenna
cable firmly into the
antenna socket of
the device.
Please contact your
car workshop or a
vehicle specialist.
(For other manu-
facturers there are
specific phantom
power supply adapt-
ers and voltage
adapters available.)
Tune in to a radio
station manually.
DVD not finalised. Use a finalised DVD.
Data flow is
"sluggish". (See
section "Operat-
ing Instructions"
on page 7 for a
detailed explana-
tion).
Before playing a CD, wipe it off
with a clean, dust-free cleaning
cloth. Pull out the CD in the
direction of the arrow.
CAUTION: do not use any solvents such as petrol
If the CD is inserted with the
printed side facing downwards,
the device may be damaged.
Always insert the CD with the
label facing upwards.
CAUTION: if there is already a cd in the cd slit, do
Always hold CDs by the edge. In
order to keep the CD clean do
not touch the surface.
Solution
Pause play using the
Tbutton. Wait a
few seconds and re-
start playback.