Honeywell HD3U Quick Install Manual

Day/Night Ultra Wide Dynamic
Fixed Dome Camera
Quick Install Guide
Document 800-05023 – Rev A – 11/09
Thank you for purchasing a Honeywell Day/Night Ultra Wide Dynamic Fixed Dome
Camera. Before installing the camera, please verify your model and read this guide
carefully:
Model Signal format Lens
HD3U NTSC 2.8 to 10.5 mm Vari-focal Auto Iris lens
HD3UX PAL 2.8 to 10.5 mm Vari-focal Auto Iris lens
Unpack Everything
HD3U/X camera Owner's Service
manual monitor
cable
You will also require a Phillips screwdriver and side-cutters.
3

Adjust the Camera

To adjust the HD3U/X Camera:
1. Apply 12 VDC or 24 VAC power to the camera and monitor the video signal.
2. Loosen the screws that lock the gimbal assembly in place (see ?).
3. Adjust the camera gimbal to the desired view.
4. Tighten the screws to lock the gimbal assembly in place.
Note Orient the camera as shown in "Adjusting the Lens Focus" to
maintain the correct picture orientation.
Document 800-05023 – Rev A – 11/09
1
Remove the Dome Cover
Before you can mount or adjust your HD3U/X, you must remove the dome cover.
Insert a coin or screwdriver in the slot on the dome cover, then twist to pry the dome
cover from the camera base.
Dome
cover
Camera
base
Mounting Mounting
screws template
Adjusting the Lens Focus
Lenses are pre-focused at the factory. In the unlikely event that the optical effect of
the dome cover causes a slight defocusing of the lens, hold the dome cover over the
lens to make a final adjustment.
Legend:
1. Adjust the vertical angle
2. Adjust the horizontal angle.
3. Adjust the horizontal positon.
4. Focus (Far or Near)
5. Zoom (Tele or Wide)
2

Mount the Camera

The HD3U/X camera is designed to be surface mounted on a wall or ceiling.
1. Attach the mounting template to
the wall or ceiling.
2. Drill four holes according to the
mounting template, then insert
anchors (not supplied) into the
drilled holes.
3. Pull power and video cables
through to the connectors. See
"Connect the Wiring".
4. Use the four screws (supplied) to
attach the camera to the wall or
ceiling.
Note Leave the dome cover off
until you have adjusted the
camera.
Connect the Wiring
Video output
Power input
Function Terminal Remarks
Color
Video Yellow 1.0 Vp-p
output
Power Green 24 VAC (20V~28V) or 12 VDC (10V~15V),
input Max 3.8 W, 310 mA
The power connections are not polarity sensitive.
Use 24 VAC ~ power source or 12 VDC power source.
Ceiling
Mounting
template
Camera
base
Mounting
screws
Dome
cover