Errdisable Detect Cause Small-Frame - Cisco Catalyst 2960 Command Reference Manual

errdisable detect cause small-frame

errdisable detect cause small-frame
Use the errdisable detect cause small-frame global configuration command on the switch stack or on
a standalone switch to allow any switch port to be error disabled if incoming VLAN-tagged packets are
small frames (67 bytes or less) and arrive at the minimum configured rate (the threshold). Use the no
form of this command to return to the default setting.
Syntax Description This command has no arguments or keywords.
Defaults
This feature is disabled.
Command Modes Global configuration
Command History Release
12.2(44)SE
Usage Guidelines This command globally enables the small-frame arrival feature. Use the small violation-rate interface
configuration command to set the threshold for each port.
You can configure the port to be automatically re-enabled by using the errdisable recovery cause
small-frame global configuration command. You configure the recovery time by using the errdisable
recovery interval interval global configuration command.
Examples This example shows how to enable the switch ports to be put into the error-disabled mode if incoming
small frames arrive at the configured threshold:
Switch(config)# errdisable detect cause small-frame
You can verify your setting by entering the show interfaces privileged EXEC command.
Related Commands Command
errdisable recovery cause
small-frame
errdisable recovery interval
interval
Catalyst 2960 Switch Command Reference
2-102
errdisable detect cause small-frame
no errdisable detect cause small-frame
Modification
This command was introduced.
Chapter 2
Description
Enables the recovery timer.
Specifies the time to recover from the specified error-disabled state.
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-04