Table of Contents
Advertisement
Available languages
Available languages
Connecting the Units
Note:
•
This product is for vehicles with a 12-volt battery
and negative grounding. Before installing it in a
recreational vehicle, truck, or bus, check the bat-
tery voltage.
•
To avoid shorts in the electrical system, be sure
to disconnect the ≠ battery cable before begin-
ning installation.
•
Refer to the owner's manual for details on con-
necting the power amp and other products, then
make connections correctly.
•
Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
•
Route and secure all wiring so it cannot touch
any moving parts, such as the gear shift, hand-
brake and seat rails. Do not route wiring in
places that get hot, such as near the heater outlet.
If the insulation of the wiring melts or gets torn,
there is a danger of the wiring short-circuiting to
the vehicle body.
•
Don't pass the yellow lead through a hole into
the engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
•
Do not shorten any leads. If you do, the protec-
tion circuit may fail to work when it should.
•
Never feed power to other equipment by cutting
the insulation of the power supply lead of this
product and tapping into the lead. The current
capacity of the lead will be exceeded, causing
overheating.
25
•
When replacing fuse, be sure to use only fuse of
the rating prescribed on the fuse holder.
•
To prevent incorrect connection, the input side of
the IP-BUS connector is blue, and the output side
is black. Connect the connectors of the same col-
ors correctly.
•
Cords for this product and those for other prod-
ucts may be different colors even if they have the
same function. When connecting this product to
another product, refer to the supplied Installation
manuals of both products and connect cords that
have the same function.
About the V.SEL cable
Use to connect to an Audio Visual Master
Unit, TV tuner or other component featur-
ing a V.SEL cable connection jack. If you
have an Audio Visual Master Unit and a
TV tuner, give priority to connection of
the Audio Visual Master Unit.
Note:
•
When connecting the Audio Visual Master Unit
refer to the Audio Visual Master Unit Installation
Manual.
Advertisement
Chapters
Table of Contents
