Kenwood KAC-X1R Instruction Manual page 6

Controls
rr- -""
1II
L
I=:J
@ •••
°1
UII.~
000 00, '0
lQ
unit
in the band with the
eliminated. band rejection
the vehicle compartment and standing
to <Specifications> in the instruction
®
LPF(Low-Pass Filter) FREQUENCY control
Sets the cutoff frequency when the switch to "ON".
BOOST LEVEL (Bass boost level) control
Sets the level by which the low frequency range should be boosted.
Power Indicator
FREQUENCY (Bass boost frequency) control
the center frequency around which the low frequency range should be
boosted.
ISF FREQUENCY control
the cutoff frequency when the "ISF" switch is to "ON".
@ BRF (band reject filter) switch
When this switch to "-6dB"/"-12dB",
"B,R.F. FREQUENCY" control
aliows to reduce resonance
waves. (page 7)
@ B.R.F. FREQUENCY control
the rejection frequency when the "BRF" switch set to "-6dB"/"-12dB".
(page 7)
LPF(Low-Pass Filter) switch
This switch allows to apply low-pass filtering to the speaker outputs.
• OFF position:
The entire bandwidth is output without filtering.
• ON position:
The filter outputs the band of lowel' frequencies than the frequency
with "LPF FREQUENCY" control.
@ INPUT SENSITIVITY control
this control according to the pre-output level of the
connected with this unit.
@
Control knob
Allows you to switch between and determine Menu System items.
PHASE switch
When this switch "180°" (Reverse) the speaker output phase reversed.
@
ISF (Infrasonic filter) switch
When this switch is to "ON", the inaudible, ultralow beIov",
set with the "ISF control cut Improves
ron,r""l, ''-''i"n
by eliminating unnecessary
"LPF", "INPUT SENSIVITY" control and
terminal.
control panel under dressing cover. Remove to
to controls for adjustment.
ON position:
audio adjusted when
boost output to the "LINE
OFF position:
The audio input from the "LINE IN" terminal is output to the "LINE OUT"
terminal output).
Controls the unit power. to connect it with all the systems.
Speaker output terminals
As this unit speakers with minimum impedance of 1 ohm, connect
with or higher impedance to terminals.
.-------.1
of the should be no than the maximum output
Otherwise malfunction may result.
REMOTE terminal
Connects the Remote
volume of the audio output to the "LINE OUT" terminal is different in
"ON" and "OFF" position. Remember this when changing the "LINE OUT
FILTER" switch from "ON" to "OFF".
@ RESET button
the microprocessor of the unit.
®
LINE IN terminal
@
LINE OUT terminal
The audio signal with the "LINE OUT switch will be output.
(fj)
Power Indicator
when POWER switch is turned On.
indicator flashes several seconds when the POWER switch turned On
or when the Protection function is activated.
of the accessory.
(j) LINE OUT FILTER switch
Changing over audio signal output to the "LINE OUT" terminal.
CD
Fuse (25 A x
3)
Battery terminal
@ Ground terminal
o
Power control terminal
Controls the unit ON/OFF.
6
English