Safety Precautions - Kenwood KAC-X1R Instruction Manual

Safety precautions
panel with a dry
furn the power OFF and release the protection, If the "E-02" code does not disappear,
When the speaker cord is shorted
"E99"
"Eor
When the unit has failed and direct current voltage IS generated to the speaker's
Protection function
There Protection function installed in the unit to protect the unit and
speakers from various problems. When Protection the display informs
you of the condition.
To prevent battery rise
When the unit
used in the ACC ON position without turning the engine ON, it
depletes the battery. Use it starting the engine.
Do not wipe the panel with hard cloth or cloth dampened by volatile
solvents such paint thinner and can scratch the surface of the
panel and/or the indicator letters to off.
Cleaning the unit
If the front dirty, turn off the power and wipe
silicon cloth .
wiring
or excessive
possibility of water
nn'cn'ih,'r
rating. Using
power supply With a negative
To prevent damage to the machine, take the following
precautions:
Be unit connected to 12V
ground connection.
Do not open top or bottom covers of unit.
Do not install the unit in spot to direct
or humidity. /\Iso avoid places too much dust or
splashing.
When
ACAUTION
AWARNING
To prevent injury or fire, take the following precautions:
• Mounting and wiring this product skills and For
leave the mounting and wiring work to nr(,t,o':cir",~dc
• When the battery, or
wires or wires with mm
2
(AWG
to prevent wire deterioration
prevent short circuit, never put or
or metal tools) inside the unit.
If the unit to emit smoke or
Immediately and consult your
not touch the unit during because the surface of the unit becomes
hot and may cause burns if touched.
as an
terminal. Do
going to connected should
(in Watts) of the amplifier. of
are than the output power of
emitted well damage.
;rY1,no,-hr""
of 1() or When more than one
When voltage gets out of operation range
"VOLT" display IS
blinked.
from the battery. If It's connected to
It can cause fuses etc.
• If Is heard from the speakers when the engine running,
connect noise filter (optional) to each of the battery wire.
• Do not allow the wire to directly contact the edge of the iron plate by using
Grommets.
• Connect the ground wire to metal part of the chassis that
electrical to the battery's negative
not turn power on the wire not connected.
Be sure to install a
or()tP(~tl\i'P
fuse in the power cord near the
protective fuse be the same capacity as unit's fuse
somewhat larger.
For cord and ground, use vehicle
cord a current than
wiring cord with 10
• When more than one
wire protective
maximum current drawn
or
the
in the instruction manual. The user could
equipment if an unauthorized change or
CW""CH'onr,n)
problems during installation, consult your Kenwood dealer.
not to working right, consult your Kenwood
FCC WARNING
This may generate or use radio
mCldificatiolis to this
modifications
the authority to operate
modification is made.
This Class B digital apparatus complies with Canadian ICES-Om.
found to limits for
device, pursuant to Part 1 of the limits
to provide reasonable protection against harmful interference in
U"'rl~~;-'~I installation. This equipment harmful to
radio communications, if it is not installed used in accordance with the
instructions. However, there is no guarantee that interference will not occur in
particular installation. If this harmful interference to radio
or television reception, can determined turning the off
and on, the user encouraged to try to correct the int.~rtcmc""o
of the
• Reorient or the receiving antenna.
the separation between the equipment and receiver.
• Connect equipment into an outlet on circuit different from that to which
the connected.
• Consult the dealer or an radlolTV technician for help.
NOTE
FCC NOTE
Information on Disposal of Old Electrical and Electronic
Equipment (applicable for EU countries that have adopted
separate waste collection systems)
)t
pro,d."ctS with t h e . . (crossed-out wheeied bin) cannot be
and
• faCility capable of handling
_ Contact your local
nearest to you. Proper and waste disposal
resources whilst preventing detrimental
environment.
.
..
. .
4Q :
kli·~~li··············
Combined Impedance
Product
norby
not installed bv
professional . -
manufacturer of vehicle on production
of vehicle into an Member