GE EX30000 User Manual

User's Guide
Model: EX30000
SLIMLINE CORDED PHONE
visit our website
www.thehomephones.com
Model EX30000
P/N: 905-30000104-NL
EX.E Version 1.0 08/2011
Printed in China
© 2011 CCT Tech Global Limited
Parts checklist
Your telephone package includes the items shown below.
Handset
User's Guide
Model: EX30000
SLIMLINE CORDED PHONE
User's guide
Before You Begin
Telephone Jack Requirements
To use this phone, you need an RJ11C type
modular telephone jack installed. If you do
not have a modular jack, call your telephone
service provider to find out how to have one
installed. If you have DSL high speed Internet
service, a DSL filter is required (not included).
Contact your DSL service provider for more information about
DSL filters.
Telephone installation
Installing on a desk or table
1. Plug the telephone line cord ending with the coiled part into
the jack at the bottom of the handset.
2. Plug the other end of the telephone line cord into a modular
wall plate (not included) as shown in figure 1 below.
3. Store the excess telephone line cord in the grooves under the
base as shown in figure 2 below.
4. Position the base with the larger end facing up as shown in
figure 1 below.
5. Place the handset onto the base.
Figure 1
is a trademark of
The General Electric Company,
Figure 2
and is under license by
CCT Tech Global Limited,
Central, Hong Kong
Telephone
Base
line cord
1
Wall plate
Modular
telephone
line jack
2
Installing on a wall
1. Rotate the base until the engraved text "TOP" on the bottom
of the base is correctly oriented.
2. Hold the straight end of the line cord so that about 2
inches of cord is available to plug into jack. Then route the
remaining cord through the grooves under the base and
wrap the excess cord around the posts on the back of the
base as shown in figure 3.
3. Wrap the cord until reaching the coiled end and route the
cord through the slot at the bottom of the base.
4. Plug the line cord into the wall jack. Slip the mounting holes
on the base over the wall plate posts and firmly slide the unit
down into place as shown in figure 3 below.
5. Plug the coiled end of the line cord into the handset.
6. Place the handset onto the base. Check installation by
picking up handset to check for dial tone.
TOP
NOTE: To prevent the handset
from falling out of the cradle
while the phone is hanging on
the wall, make sure the base is
rotated to the correct position
as shown.
Figure 3
3
Handset Layout
Earpiece (receiver)
redial button
ringer volume
switch
Microphone
4
TOP
switch hook
flash button
receiver
volume switch