Setting The Clock; Detaching The Front Panel; Attaching The Front Panel - Sony CDX-GT320 Operating Instructions Manual

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ball-point
pen.
Note
Pressing the RESET button will erase the clock setting
and sam€' stored contents.
Before using the card remote commander for the
first time, remove the insulation film.
Tip
For how to replace the battery, see "Replacing the
lithium battery of the card remote commander" on
page 13.
The clock uses a 12-hour digital indication.
1
Press and hold 'the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press
(SEEK)
+.
The hour indication flashes.
4
Rotate the volurne control dial to set
the hour and minute.
To move the digital indication, press
(SEEK)
-/+.
5
Press the select button.
The setup is compllete and the clock starts.
To display the clock, press
(DSPL).
Press
( DSPL)
again to return to the previous display.
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press
(OFF ).
The unit is turned off.
2
Press
~,
then pull it off towards you.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in
a
parked
car or on
a
dashboard/rear tray.
Attaching the front panel
Engage part
®
of the front panel with part
®
of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
•
5