Removing The Unit; Specifications - Sony CDX-GT320 Operating Instructions Manual

e
Pull out the release keys to remove the
protection collar.
Hook facing
inwards.
CEA2006 Standard
Power Output: 17 Watts RMS
x
4 at
4
Ohms <
1 %
THD+N
SN Ratio: 82 dBA
(reference:
1
Watt into
4
Ohms)
e
Slide the unit out of the mounting.
SaBcilicelions
e
Pull the release keys to unseat the unit.
CD Player section
Signal-to-noise ratio: 120 dB
Frequency response: 10 - 20,000 Hz
Wow and flutter: Below measurable limit
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION
23.2 watts per channel minimum continuous
average power into 4 ohms, 4 channels driven
from 20 Hz to 20 kHz with no more than 5% total
harmonic distortion.
2
Remove the unit.
o
Insert both release keys simultaneously
until they click.
~
~
Fuse (10A)
Back of the front
panel
Main unit
Notes
• For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
• Never touch the connectors directly with your fingers
or with any metal device.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.
Rlm••
inIlIIlB unil
1
Remove the protection collar.
o
Detach the front panel (page 5).
e
Engage the release keys together with the
protection collar.
Cleaning the connectors
The unit may not function properly if the connectors
between the unit and the front panel are not clean. In
order to prevent this, detach the front panel (page
5)
and clean the connectors with a cotton swab. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Fuse replacement
When replacing the fuse, be
sure to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse
blows again after replacement,
there may be an internal
malfunction. In such a case,
consult your nearest Sony
dealer.
14
•