Command Line Interface
DGS-1210-24:admin#logout
**********
* Logout *
**********
ping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.90.90.6:
DGS-1210-24:admin#ping 10.90.90.6
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
--- 10.90.90.6 Ping Statistics ---
5 Packets Transmitted, 5 Packets Received, 0% Packets Loss
DGS-1210-24:admin#
reboot
Purpose
Syntax
Description
Parameters
NOTE: Save your configuration changes before
logging out.
This command is used to test the connectivity between the Switch
and other network devices.
<ipaddr>
The ping command checks if another IP address is reachable on
the network. You can ping the IP address through the managed
VLAN (VLAN 1 by default), as long as there is a physical path
between the Switch and the target IP equipment. By default, the
Switch sends five pings to the target IP address.
<ipaddr> - Enter the IP address of the host.
None.
This command is used to reboot the Switch. If the Switch is a
member of a stack, it may be rebooted individually, without
affecting the other members of the stack.
reboot
The reboot command reboots the Switch. All network connections
are terminated and the boot code executes.
None.
9
5
9
5
D-Link Web Smart Switch User Manual