Table of Contents
Advertisement
4.4.2 Policy Configuration
System supports up to 10 individual policies, each of which consists of access control profiles that can be applied
to a certain group of users. In the DSA-6100 system architecture, a group of users are associated with an
authentication method which is defined by Authentication Server configuration. On the other hand, the Global
policy also consists of access control profiles and can be globally applied to all users.
I.
Global Policy:
Global Policy is the system's universal policy including Firewall, Specific Route and VLAN Isolation Profiles
constrained all network users unless the network user is already regulated and followed the control rules of the
other policies. The Global Policy applies to all users. Once a policy is configured, you may assign the policy to
any authentication server. Two authentication servers may share the same policy.
Select Policy: Select Global for setting up Global policy configuration.
Firewall Profile: Global firewall rules can be defined and applied to all users.
Specific Route Profile: Static routing rules can be specified to route IP traffic from the system
to the destination in a controlled fashion.
VLAN Isolation Profile: Default isolation rule can be selected to pass or to block all traffic
between VLAN and LAN interfaces. In addition, exception rules can be set up to accompanied
with the Default rule.
Maximum Concurrent Sessions: The maximum number of concurrent sessions which is
allowed to be established by each user.
Select Profile: Select Global to set the Firewall Profile, Specific Route Profile and VLAN Isolation
Profile.
Firewall Profile: Click the hyperlink of Setting for Firewall Profile, the Firewall Profiles list will appear.
Click the numbers of Filter Rule Item to edit individual rules and click Apply to save the settings. The
rule status will show on the list. Check Active to enable that rule.
Chapter 4. Web Interface Configuration
101
Advertisement
Table of Contents
